§ 1002. Dimensional requirements.

(a)

The following chart lists the requirements within the I-1 and I-2 Industrial Districts for minimum lot area, width, yard spacing and maximum floor area ratio for all uses and structures.

		Industrial I-1	Districts I-2
(1)	Minimum lot area in square feet:	20,000	20,000
(2)	Minimum lot width in feet:*	100	100
(3)	Minimum front yard setback in feet:	30	30
(4)	Minimum side yard setback in feet unless a greater setback is required by section 1003:	0	0
(5)	Minimum side yard setback adjacent to a street in feet:	30	30
(6)	Minimum rear yard setback in feet, unless a greater setback is required by section 1003:	0	0
(7)	Maximum floor area ratio:	2.5	2.5

 

*Where applicable, newly created corner lots must also adhere to section 4.4(c) of the Subdivision Ordinance, requiring additional lot width on certain corner lots.

(b)

Front and side-yard setbacks adjacent to a street may be reduced in accordance with the provisions of Part H of Article 2.

(Ord. No. 1948, 2-12-90; Ord. No. 3384, 12-2-14)

(Ord. No. 1948, 2-12-90; Ord. No. 3384, 12-2-14)